Disclaimer

Disclaimer: RME's web-based mill relining benchmarking scorecard calculator is based on information from sources which RME considers reliable, however its accuracy and completeness cannot be guaranteed.

This calculator is intended to provide general information only and does not constitute or form the basis of, and should not be relied on in connection with any contract or commitment whatsoever. The information in this calculator does not take into account site specific conditions and information. Nothing contained in this document constitutes advice unless we have specifically identified the advice and we have rendered a separate fee to you for such advice. We encourage you to seek appropriate independent advice, if necessary, to determine the suitability of the information contained in this calculator. This website does not, and does not purport to, contain all the information anyone would desire or require in reaching a decision.

This document contains certain forward-looking comments such as to potential improvements or increased efficiencies. These forward-looking comments are provided as a general guide only and involve known and unknown risks, uncertainties and other factors which are subject to change without notice and there can be no assurance that actual outcomes will not differ materially from these comments. 

All intellectual property rights in this website belong to RME. These intellectual property rights are protected by Australian and international laws. No material contained in this website may be copied, reproduced, distributed, modified, transmitted, reused, re-posted, or published without RME’s prior written permission.

To the maximum extent permitted by law:

a.    no warranty or representation is given by RME or any of its subsidiaries, directors, employees, associates, affiliates or agents to any party in relation to the documents accuracy or completeness or its fitness for any purpose or at all nor is any such warranty or representation implied; and

b.    none of RME and its subsidiaries, directors, employees, associates, affiliates or agents, nor any other person accepts any liability for any loss, claim, damages, costs or expenses of whatever nature (whether foreseeable or not and whether indirect or not) suffered by you or any person acting on the document or arising as a consequence of the information in the document, whether such loss or damages arises in connection with any:

i.    fault or negligence on behalf of RME, its subsidiaries, directors, employees, associates, affiliates or agents;

ii.    inaccurate comment, errors or omissions in the document; or

iii.    other cause.

Return to RME's Mill Relining Benchmarking Scorecard